uCXpresso LilyPad for nano51822 (BT4.0/4.1 Arduino iBeacon Sensor)

uCXpresso.NRF lilypad for nano51822 is a BT4.0/4.1 (Bluetooth low energy or BLE) module designed based on Nordic nRF581822 solution. the SoM chip Soldered on the lilypad breakout board. Simply provide developers a better platform.
Features:
1. Dual Transmission Mode of BLE & RF 2.4G upon customer preference.
2. Low power requirements, ultra-low peak, average and idle mode power consumption.
3. Compatible with a large installed based of Phones , tablets and computers.
4. Fully coverage of wireless applications.
5. Diameter 39.37mm (15.50") x 1.0mm
6.IOx24 ( VCC, GND, GPIOx22, ADx6, SPIx1, I2Cx1, UARTx1, PWMx6)
7.uCXpresso.NRF RTOS/BLE C/C++ Framework
8. Tickless Technology Supported.(under the global average 26uA)
9. LPCXpresso IDE Ready (for Windows, Linux, Mac OS/X).
10. No usb needed, DFU OTA (Over the Air) update F/W. (nRF DFU for Android)
11. Maximum output +4dBm, and communication distance up to 80M in field area.
12. high standard 32.768MHz XTAL.
13. The DFU Button can easily switch between DFU mode and Application Mode.
14. CR2032 button battery socket at the back of the board
15. The throuhole can easily use with (M2) screws
16. Built in voltage and temperature detection.
17. iBeacon Demo program out of factory.

nano51822 Specs:
2.4GHZ transceiver.-93dbm sensitivity in Bluetooth low energy mode .
TX Power -20 to +4dbm .
ARM Cortex - M0 32 bit processor .
Serial Wire Debug (SWD) .
RTOS 8.1.x and Tickless Technology ready .
152kb embedded flash memory 6kb RAM memory .
6+16kb RAM memory .
Supply voltage range 1.8V to 3.6V .
2.5us wake-up using 16MHz RCOSC .
8/9/10 bit ADC- 6 configurable channels .
30 General Purpose I/O Pins .
Two-wire Master (I2C compatible) .
UART (CTS/RTS)