bluesky 6pin FTDI FT232RL USB To 3.3 V Serial Adapter Module TO TTL RS232 Arduino Cable
> FTDI based USB to TTL Serial Cable FTDI chipset FT232RL 1.05M 6ft for Arduino UNO mini. The cables provide a fast, simple way to connect devices with a TTL level serial interface to USB. RX and TX LEDs indicator. The Cables are Available With A 6-way SIL,0.1" Connector> >TTL levels is 3.3V. Cables provide a fast, simple way to Connect devices with a TTL level serial interface to USB. Cable contains a small internal electronic circuit board, utilising the FT232R, encapsulaing into the USB end. The other end comes with a selection of different connectors supporting various Applications. The USB side of the cable is USB powered. Cable is 1.8m and supports a data transfer rate up to 3 Mbaud Note. > >This USB to Serial UART (TTL level) adapter allows you to connect your computer through USB port and use it as a regular serial communication port. All USB protocol is handled within this adapter. No other device or programming is required. > The board attaches directly to the USB bus via a standard type A receptacle connector. It shows up on any Windows computer as a standard serial COM port. Any applications that talk to this COM port is automatically convert to USB and back to UART to your target board.> Entire USB protocol handled by the electronics in the cable USB UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity Fully assisted hardware (RTS#/CTS#) or X-On / X-Off software handshaking. Data transfer rates from 300 baud to 3 Mbaud at TTL levels. +5V output allows external logic to be powered from the USB port. Transmit and receive LEDs. Low USB bandwidth consumption. OS Support: Windows 98, Me, XP, 2000, 2003, CE, Vista, Windows 7, and Windows 8, Linux and Mac OS 10.X 6-Pin Header Assignment: Pin 1 GND Pin 2 CTS Pin 3 VCC Pin 4 TXD Pin 5 RXD Pin 6 RTS