ZS Nokia Lumia 920 Multi Surface Mount (SKU 15923)
This ZS mount for Nokia Lumia 920 works on most flat surfaces.
The mount uses a special PU coated 60mm suction cup which
is tacky to touch but NOT adhesive, it can be removed & re-applied
many times allowing adjustment of position or transfer between vehicles.
The PU coated lever release suction cup gives reliable vacuum grip that holds
firm to almost any surface in your car.
The sucker requires a minimum flat area of 70mm diameter for a good grip.
This mount will hold to textured dashboards & console areas.
So versatile, neat enough for small cars and larger vehicles such as
Motorhomes, MPVs, Lorry Cabs, Transit Vans.
If your vehicle has a deep dash or steep sloping windscreen, the ZS Multisurface
Mount allows you to bring your mobile / smart phone closer for
easier viewing.
The dedicated Lumia 920 cradle is bespoke & is designed to allow full access
to all ports & buttons, this cradle will not accommodate
a case or skin.
Arm length approx 60mm - low level design, neat & unobtrusive.
How to apply your ZS Multi Surface Mount:
Select your chosen position, ensure it's clean & dust free.
Remove the protective film from the sucker.
Position the ZS arm, pull down the lever to expel the air & create the vacuum.
Give it a wiggle to ensure it's holding firm then insert your phone onto the
dedicated holder.
To remove:
Lift the lever & pull on the release tab to break the vacuum.
The mount can now be removed.
NOTE: Please do not just pull the mount off the surface, you WILL damage it.
Washable: Dust, fluff & grease can build
up on the suction cup causing the suction to fail. If this happens simply rinse
the sucker under a running tap & leave to air dry.
Not suitable for oiled areas, loose covered dashboards or areas cleaned with wax
or grease treatments.
This bespoke cradle is not suitable for use with a case or skin.