WoodRiver Guide Rail Clamp Pair

These clamps swivel about the "T" shaped anchor and can be placed at any position along the underside of the guide rail extrusion. This system will allow you to place a tool guide for ripping, crosscutting or routing at an acute angle on any size panel. 56" guide rail component features the same heavy-duty aluminum extrusion used in the WoodRiver clamp guides. Guide rail component has 2-1/8" x 1/2" profile with integral 1/4" T-tracks. Guide rail connector locks together multiple guide rails to form a continuous guide for your circular saw or router across any length material. Guide rail clamps secure the guide rail at each end. Clamps swivel about the "T" shaped anchor at any angle. Clamps can be placed at any position along the underside of the guide rail extrusion. Unique angle jig acts as a miter gauge for the guide rail system. The angle jig references any angle from the edge between plus or minus 60 degrees. The angle jig has positive stops at 90 degrees, plus or minus 30 degrees, plus or minus 45 degrees and plus or minus 60 degrees.