Wireless Water & Temperature Sensor Black w/LED; Cert ID: ZC08-11030007

If water is detected at the monitoring location or an over/under-temperature conditions is detected, the unit will send an alert message(s) to the Z-WaveTM network (if included in the network). The type of alert message depends on how the WWA-02AA is configured. If Water or Heat Alarms have been configured then the WWA02AA will send alert messages to the Node ID that configured the alarm. Drying the sensor contacts will clear the Water Alarm. If an over/under temperature Alarm occurred and the temperature alarm conditions are no longer present, an 'alarm clear' message is also sent to the Z-WaveTM network (if included in the network). Also, depending on your Z-WaveTM controller, it is possible to receive a remote alert. You can receive an email or cell phone text message when an alarm is activated. Depending on your specific controller's capabilities you will be able to remotely check the status of any WWA-02AA in your network. Low Battery The WWA02AA will send an alert on the Z-WaveTM network at regular intervals when it detects a low battery condition. In addition, it will periodically blink the LED. Your controller may be able to be configured to monitor the unit's wake up notifications. Configuring the WWA02AA The high and low temperature setpoints in the WWA-02 can be configured. The low temperature setpoint must always be set at least two degrees below the high temperature setpoint. The low temperature setpoint cannot be set less than -10 degrees C and the high temperature setpoint cannot be set greater than 70 degrees C. The temperature setpoints can be configured via a 'smart' controller after inclusion; details are provided in the technical appendix. Temperature Reports If your controller sends the wakeup interval set command, the controller will also become the Wakeup Master node. The WWA02AA will automatically send temperature reports to this Wakeup Master node within a half hour of a 1 degree C change in temperature.