Weigand Ruger Single Six Revolver Scope Mount. Silver

PLEASE NOTE: This mount is not intended for use on the RUGER Single 7 .327 Federal Magnum Our Ruger Redhawk Drill and Tap Mount Will Work For That Application, Click The Following Link For Details Ruger Redhawk Blackhawk Bisley GP-100 Scope Mount Finally a no drill and tap WEIG-A-TINNY style scope mount for the Single Six. This Single Six scope mount requires no drilling or tapping of your frame. Handsome, lightweight and durable. Blends beautifully with the lines of the Ruger frame. Accepts all Weaver and most Picatinny style rings and accessories. 4-1/2" long, weighs 1.3 ounces. This scope mount attaches to the rear sight elevation adjusting screw hole. You first remove the single six rear sight and replace it with our scope mount. Then insert the supplied screw into the elevation adjusting screw hole and tighten. In the front there is a nylon tipped set screw, that gets adjusted down just until it touches the top strap.* All of the testing of this mount was done with .22 Magnum without a single issue. We have sold hundreds of these mounts with tremendous success. *Over tightening of the set screw can cause point of impact problems. It will cause the revolver to hit low.