Vktech Cloning Garage Door 433 315MHz Wireless Metal Remote Control Duplicator (433MHz)


Using the steps and methods:
Step 1: clean code
Two fingers while holding the remote control first key and the second key (above two keys) indicator flashes rapidly, then release your finger, press any key on the remote button, the indicator light indicates that clean code is not long success. (Flashes about once went out)
Step 2: Copy
In each hand a remote control, a remote control just to match, one simply Remote Control Duplicator.
Two remote control tightly close, while holding the remote to match the remote control and copy the first key, see Remote Control Duplicator indicator flashes rapidly, release the hand press this key indicator light long after learning code indicates success .
The same methods were replicated in a second key, the third key ...... thus similar push. If all copied successfully, after copying the remote functions and remote control key functions to be matched exactly.
Step 3: Use
If done correctly, it can be used directly. If not, or did not use a single button, the remote control code again after clearing again, copy Operation process, the attention indicator light changes.
If the problem persists, try a few times, check again chip and original remote control frequency, no problem and can not Duikao please contact us.

Precautions
1. Select Remote Control Duplicator necessary condition: original remote control functions properly, the chip compatible with the correct frequency.
2. Remote Control Duplicator can only copy fixed code and learning code remote control chip (chip models see description paragraph).
3. Automotive original remote control, two-way remote control, rolling code remote control, IC procedures encrypted remote control can not be copied. Such as HCS200, HCS201, HCS300, HCS301 and so on.

Includes:
1* Remote Control Duplicator