Upgrade Screw Kit for Magpul MOE Poly Trigger Guard

Upgrade Screw Kit for easy installation and removal of Magpul MOE Poly Trigger Guard. Don't risk breaking your Lower Receiver with the roll pin! Many people have broken their receiver trying to install or remove the roll pin for the trigger guard. It can be difficult or even impossible to repair and may never work right again. You can remove your guard safely with no modification to your receiver. Two brass inserts allow this guard to be easily installed with out a roll pin. This also includes 12.9 grade screws, two shorter for the rear and one longer for the front. Instructions: The front hole does not require any modification. The rear trigger guard hole must be drilled with a 5/32" bit to make proper room for the inserts. The smooth side of the insert faces out and the side with the slot faces into the hole, as shown in the picture below. Carefully press one insert at a time into each side of the rear hole. Keep the insert straight at all times to avoid damaging them. I will not send replacement inserts because you damaged them. This can be done with an arbor press, vice, vice-grips, or pliers but care must be taken. Press the inserts in until they are flush, they must be flush with the surface. Now the guard is ready to install. Use a 2mm hex wrench to install the screws. Be careful not to over tighten them. They just need to be snug. The two shorter screws are for the rear and the longer is for the front. Buyer assumes all responsibility and liability of this product and hold Seller harmless from any and all loss or injury to persons or property arising out of handling, use or possession this product. Seller shall have no liability.