Upgrade Screw Kit for Magpul MOE Enhanced Aluminum & LWRC Poly Trigger Guards

Upgrade Screw Kit for easy installation and removal of Magpul Enhanced Aluminum Trigger Guard. Don't risk breaking your Lower Receiver with the roll pin! Many people have broken their receiver trying to install or remove the roll pin for the trigger guard. It can be difficult or even impossible to repair and may never work right again. You can remove your guard safely with no modification to your receiver. Two brass inserts allow this guard to be easily installed with out a roll pin. This also includes 12.9 grade screws, two shorter for the rear and one longer for the front. Instructions: The Front and Rear trigger guard holes must be drilled with a 5/32" bit to make proper room for the inserts. The smooth side of the insert faces out and the side with the slot faces into the hole, as shown in the picture below. Carefully press one insert into the right side of the front hole. Carefully press one insert at a time into each side of the rear hole. Keep the insert straight at all times to avoid damaging them. This can be done with an arbor press, vice, vice-grips, or pliers but care must be taken. Press the inserts in until they are flush with the surface. Now the guard is ready to install. Use a 2mm hex wrench to install the screws. Be careful not to over tighten them. They just need to be snug. The two shorter screws are for the rear and the longer is for the front. The same instructions will work for most trigger guards including the LWRC and Magpul MOE Poly. Buyer assumes all responsibility and liability of this product and hold Seller harmless from any and all loss or injury to persons or property arising out of handling, use or possession this product. Seller shall have no liability. This item is new. See Product Description for instructions as they are not included.