Uniquetek Toolhead Clamp Kit™

Take Control of OAL! The UniqueTek Toolhead Clamp KitTM enables the toolhead of Dillon 550 & 650 presses, or the die plate of RCBS Pro 2000®/ PiggybackTM -3 & -4 presses, to be CLAMPED into the press frame. This corrects the loose fit between the toolhead and press frame, thus reducing OAL (overall length) variation and stabilizing die-to-shellplate alignment. Your press frame remains unmodified so you can still use standard toolheads/die plates with the original toolhead pins ... and your original manufacturer's warranty will not be affected. Advantages • Eliminates Loose Toolhead-to-Frame Fit • Reduces OAL Variation* • Improves Crimp Repeatability • Improves Bullet Concentricity from Seating Die • Reduces Jams at Size/Decap Die It also reduces vibration and stops toolhead rattling when using the Dillon Rapid Trim Case Trimmer! Works With The Following Presses • Dillon XL 650, RL 550B, BL 550, AT 500 and SL 900 • RCBS Pro 2000® and PiggybackTM -3 & -4 RCBS Presses? Yes! The Toolhead Clamp KitTM works equally well on RCBS Pro 2000® and PiggybackTM -3 & -4 presses! What Comes in the Kit The UniqueTek Toolhead Clamp KitTM comes complete with all the parts needed for 2 presses and 6 toolheads in a resealable plastic bag (toolheads not included). Each kit includes*: • Installation Tool for threaded inserts • 9/64" HSS Drill Bit • STI Thread Tap • 12 Stainless Steel Thread Inserts • 4 grade-8 Alloy Steel Clamp Screws with Moly Anti-seize Coating • 4 Stainless Steel Washers • Hex-key to Tighten the clamp screws • Detailed Step By Step Instructions * Quantities listed are for small sized kit.