USB to TTL Serial Cable FTDI chipset PL2303HX 1M 3.2ft for Arduino UNO mini

The USB to TTL Serial Cable FTDI chipset PL2303HX 1M 3.2ft for Arduino UNO mini. The TTL-PL2303HX cables are a family of USB to TTL serial UART converter cables incorporating FTD's PL2303HXQ USB to Serial UART interface IC device which handles all the USB signaling and protocols.The cables provide a fast, simple way to connect devices with a TTL level serial interface to USB.The cables are available with a 4-way SIL, 0.1" connector, a 3.5mmAudio Jack, an 8 way, keyed 2mmpitch connector (intended for use with VMUSIC2 or VDRIVE2) or bare, tinned wire ended connections. FTDI based USB to TTL Serial Cable are designed using the the standard PL2303HX chipset. Each cable is 1m long and supports a data transfer rate up to 3 Mbaud.

Specification:
TTL levels is 3.3V.
Size:The length of the cable: 1.0m
Color: black
Package weight: 1.0 oz/29g

Compatible modes:
The USB side of the cable is USB powered and USB 2.0 full speed compatible.

The functions of the small panel of the converting port.
1.Simply transfer the information.
2.Router and ADSL device upgrade.
3.GPS transmission
4.Hard drive disk device upgrade
5.Conveniently use, connecting the RX with TX of MCU, and connecting the TX with the RX of MCU, then connecting to up GND without need the MAX232 converting.
6.Using in the hyperterminal, usually use the adjust tools of the port.
7.Suitable for all kinds of satellite upgrading

Noteïš
Take the small panel down from the computer when setting the 3.3V and 5.5V output, and do not operate with electric, avoiding damaging the devices when setting the wire jumper cap.