USB to RS-485 Adapter W/Terminal Block Changer FTDI chip inside

USB to RS485 Adapter Overview

Professional grade USB to RS485 Converter optimized for Windows 7/8 and Server 2003/2008. High-Speed and Interface compliance, USB1.1,2.0,3.0, EIA/TIA RS-485 USB. With its 5 pin Terminal Board Changer secured by screw lock mechanisms, the USB to RS-485 adapter is capable of supporting 256 nodes on the network.

The USB-RS485-AT incorporates an FTDI Chip with its operation helping to provide a full set of RS-485 Data and Control signals. Once installed, there are no conflict issues with IRQ, DMA, or I/O resources to give its user up to a 3M baud rate transfer.

Features
- Full compliance with the USB Specification 2.0 & 1.1
- Support 256 Node on the network
- 5kV HBM ESD Protected
- Data transfer rates 300 to 3M Baud
- Supports remote wake-up and power management
- Changer adapter from DB-9F to 5 Pin Terminal block

Terminal Block Information
- Chip FTDI Pin No. DB-9(M+F) Pin No. Terminal Block
- Data Transfer Rates 3M Baud 1 B- 1 A+
- Power Consumption 56mA 2 B+ 2 B-
- LED 3 3 Non 3 G
- Operating Temp. 0°F ~ 40°F
- Storage Temp. -20°F ~ 60°F
- Humidity 0~80% RH, Non-condensing
- Compliance: USB spec. 2.0 / 1.1
- Interface: RS-485
- Connector: Host USB Type A Male
- Device: DB-9M / DB-9F to Terminal Block
- Power Mode: Bus
- Housing: Plastic