TEN-HIGH AC110V glass laser tube 50W CO2 800mm length, 50mm Dia for 400x300mm and 400x600mm 50W laser engraving and cutting machine

Notice:
1.Here is the laser engraver with this laser tube for your reference:
https://www.amazon.com/dp/B01D2PJ4VU
https://www.amazon.com/dp/B00BKWP5X4
2.To purchase a laser tube,please confirm your machine's installation space,like the diameter and length,all should be a little bigger than laser tube's size
Introduction
Model:CO2-TUBE-50W-80CM
Output Power:50W
Wavelength:10600nm
Working Voltage:15KV (Trigging Voltage=22KV)
Working Current:18mA
Divergence:1.95(beam diameter)
Dimensions:Length 800mm
Input voltage: AC 220V+30 or AC 110V+20 (to be specified when placing order).
Maximum output voltage:DC25KV (40W;50W) / DC28KV (60W) / DC35KV (80W)
Maximum output current: DC20mA (40W;50W)/ DC23mA (60W) / DC28mA (80W)
Isolation Withstand voltage: Input-output, input-enclosure: AC2000V- 10mA-60s; negative pole of output connected to enclosure.
Protection: with well-grounded enclosure, output circuit of power supply can be open for short time (but arc between positive pole and enclosure should be avoided).
Response time (from time of input being available to the output current being up to nominal value)<1ms
TTL voltage level control: effective voltage level can be high or low through setting.
Protection switch: for detection of cooling water, to protect laser device; or activate with enclosure is opened.
Laser power adjustment: (1) by adjusting the output current of power supply through resistor; (2) through PWM control (magnitude being TTL voltage level).
Environmental requirements: temperature (-10 to 40 centidegree), relative humidity<85%.