Surveillance Camera Pan and Tilt Decoder Kit

Surveillance Camera Pan/Tilt Decoder Would you like to do more with your security camera or DVR system? If your security camera system's Pan/Tilt/Zoom (PTZ) capability uses RS485 and the Pelco-D or Pelco-P standard, then this kit could help provide up to 6 relay outputs with your current system. This kit acts as an interface between your camera system and other things you want to control, like playing a recorded message, turning on a light or controlling motors, you decide. The unit can be set to a possible 255 address combinations, so multiple units can be used together. Each relay output can switch a maximum 500mA load and provides a visible red LED indicator. The outputs can be configured to operate as momentary or latching outputs. Check out what others are saying about the Surveillance Camera Pan/Tilt Decoder project build! There are additional components (offsite) that are required to complete the project, please review the section below before purchasing the kit. You Will Need PICAXE 18M2 Microcontroller: You will NEED to program the IC with a PIC Programmer and the source code is available above as "Sample Code". Connector Soldering iron and solder Masking tape (optional) Wire cutters Digital Multimeter (optional) Needle nose pliers Kit Includes: