Sunwin USBCNC 4 Axis Interface Board Nema23 Dual Shaft Stepper Motor Controller CNC Kit
1. USBCNCV4X USB Interface Board
Technical parameters:
Minimum configurationïš
1) CPUïš1GHzï›
2) RAM:512MB
3) DISK:500MB
4) DIRECTX9 graphics device with WDDM 1.0 or higher driver
5) USB 2.0 PROT
6) .net FRAMEWORK 3.5SP1
Recommended configurationïš
1) CPUïš2GHz Dual-Coreï›
2) RAMïš2GBï›
3) DISK:1G
4) DIRECTX9 graphics device with WDDM 1.0 or higher driver
5) USB 2.0 PORT
6) .net FRAMEWORK 3.5SP1
2.FMD2740A stepper motor driver
1)High-performance, low price
2)constant current chopping driving technology
3)Power supply voltage 12 to 40VDC
4)High-speed optocoupler signal isolation input
5)20kHz chopping wave frequency
6)Subdivision precision 2ã€Â1/8ã€Â1/16ã€Â1/32ã€Â1/64ã€Â1/128ã€Â1/10ã€Â1/20 optional
7)Electrical input signal is TTL compatible
8)Automatic current halving in rest
9)Easy to ass emble in terms of appearance design
10)Maximum drive current is 4A
11)Could drive any two or four-phase hybrid stepping motor with 4A Phase one time
3.23HS2430B Dual shaft stepper motor
Model:23HS2430
Step: 1.8°
Motor Length: 112mm
Rated Current:3A
Phase Resistance:1.6Ohm
Phase Inductance:6.8mH
Holding Torque:280N.cm
Detent Torque:12N.cm
Rotor Inertia:800g.cm2
Lead Wire:4
Motor Weight:1660g
What is in box ?
1 x 4 axis USBCNC breakout board
1 x Hand controller
1 x USB cable
4 x FMD2740A stepper motor driver
4 x 23HS2430B Dual shaft stepper motor
1 x 400W 36V 11A power supply
1 x CD(With manual and software)