Stepper Motor Driver, DROK DC-DC Stepping Motor Module 5-30V 9V 12V 24V V3 Dual H-Bridge 4-Channel 2A Step Motor Driver Controller Board Chip with USB Port - 091049

Product Description:
This dual L298N driver module, using ST's L298N new original chip, and high stability SMT process, with high-quality electrolytic capacitors to make the circuit work stably.
It can directly drive two 3-30V DC motor.
And it provides a 5V output interface (the min input is 6V) to power for 5V single-chip circuit (low ripple factor).
It also supports 3.3V MCU ARM control, you can easily control the speed and direction of DC motor, and control the 2-phase stepper motor, 5-wire 4-phase stepper motor.
Product Parameters:
Driver Chip: L298N dual H-bridge DC motor driver chip
Power Supply of Driving Terminal: + 5V ~ + 30V (the range is +6V～+30V if taking Internal power)
Peak Current of the Driving Part: 2A
Operating Current of Logical Part: 0 ~ 36mA
Control Signal Input Voltage (IN1 IN2 IN3 IN4):
Low level: -0.3V≤Vin≤1.5V
High level: 2.3V≤Vin≤Vss
Enable Signal Input Voltage (ENA ENB):
Low level: -0.3≤Vin≤1.5V (control signal is invalid)
High level:2.3V≤Vin≤Vss (control signal is active)
Max Power Consumption:20W (when the temperature T = 75 ℃)
Storage Temperature:-25 ℃ ~ + 130 ℃
Drive Board Size:90 * 55 * 33mm (with fixed copper pillar and heat sink height)
Other Expansion:control direction indicator, logical part board internal taking power interface