[Sintron] 3D Printer Controller Kit RAMPS 1.4 + Mega 2560 R3 + 5pcs A4988 Stepper Motor Driver with Heatsink + LCD 12864 Graphic Smart Display Controller with Adapter For Arduino RepRap

Overview

(1) 3D Printer Controller RAMPS 1.4
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino-compatible Mega with the powerful Arduino-compatible MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino-compatible MEGA shield for easy service, part replacement, upgrade-ability and expansion.

for more informations, you can check here : http://www.amazon.com/gp/product/B00JU41GQ4

(2) Mega 2560 R3
for more informations, you can check here : http://www.amazon.com/gp/product/B00E94CGTQ

(3) A4988 Stepper Motor Driver
A4988 is a complete microstepping motor driver with built-in translator for easy operation

for more informations, you can check here : http://www.amazon.com/gp/product/B00JXGT1G6

(4) LCD 12864 Graphic Smart Display Controller
This full graphic Smart Controller contains a SD-Card reader, an rotary encoder and a 128 x 64 dot matrix LCD display. You can easy connect it to your Ramps board using the "smart adapter" included.

for more informations, you can check here : http://www.amazon.com/gp/product/B00L72FAZU

Package List

(1) RAMPS 1.4 x 1
(2) Mega 2560 R3 x 1
(3) A4988 Stepper Motor Driver with Heatsink x 5
(4) LCD 12864 Graphic Smart Display Controller x 1
(5) Smart Adapter x 1
(6) 30cm Cable x 2
(7) USB Cable x 1
(8) Storage Box x 1


Here is the firmware for you to use with Ramps 1.4 https://www.dropbox.com/s/56qbizg7l56k2lw/Marlin-Marlin_v1%20for%20lcd%2012864.zip Marlin for ramps 1.4 + A4988 stepper driver + LCD 12864 controller