Remediation of Dirty Electricity - Pxdna (Personal Dissipative Noise Attenuation)

The PxDNA product is designed for the 50/60 Hz. power lines, 120 VAC or 240 VAC, and accomplishes the reduction of high frequency noise (dirty electricity). The frequency range over which this product is effective is approximately 5 kHz to 500 kHz, with an estimated attenuation up to 98.4% and 10 Dirty Electricity Power Dissipation Max. (watts).The DNA technology does not use a capacitor as Filters do, and works through "dissipation" by dissipating the dirty electricity off the home or office wiring by turning it into heat and creates NO increase in magnetic or electric fields. The PxDNA (Personal Dissipative Noise Attenuation) product is fundamentally different from a filter type of product. The basic architecture is to provide a low impedance path for the high frequency noise and provides a "path of least resistance" for the noise. Once the DNA has "captured" the Dirty Electricity power, it dissipates it. "Dissipate" means turning the Dirty Electricity power into heat. This heat is radiated from the product. It is important to note that once the Dirty Electricity power has been turned into heat, it cannot "get back" to "electrical Dirty Electricity". It is gone forever. Another important and fundamental difference is that it does not "carry" the power that it is conditioning. The PxDNA operates in parallel with the loads (equipment) that it is protecting from noise. The PxDNA simply plugs into a standard AC outlet and draws the noise on that AC line into itself - then dissipates it. If a single PxDNA does not provide sufficient reduction of noise power, more units can be plugged into the same circuit. Being portable it allows you to change your "installation" easily. Finally, the intent of the PxDNA is to capture and remove utility noise power as early as possible, to capture the noise while it is on the AC line before it can radiate into your living space.