Qiagraphix 20 sheets Inkjet Clear Waterslide Transfer Decal Paper
It is recommended to test a couple of prints with your printer to ensure good color performance by using glossy photo paper. 1. Print your image(s) from your computer onto your inkjet printer. Mirror the image to print if decals apply from the back of the object. 2. Print image(s) on the glossy side of the blank paper. Note: Please feed your printer one sheet at a time to avoid jamming the printer. 3. Allow the ink to dry and set into the paper for at least five minutes or more. 4. Spray crystal clear coating onto prints and let it dry in 10-15 minutes or more. 5. Cut out the image(s) as close as possible to the actual design and place them in lukewarm water for approximately 45 seconds. 6. Gently slide the decal into place; it stays moveable until you get it right! Use a clean damp cloth or paper towel to wipe off excess water and remove any air bubbles that may appear. 7. Allow setting time of about 3 hours. Your decorated object is ready! Note: For speeding up drying time by placing decorated object under the sun or near a fan.