A class A/B amplifier uses two groups of transistors and it is generally considered to be the best compromise of the two classes put together. Class €˜A€ and class €˜B€. A pure class €˜A€ amplifier typically has an enormous amount of current flowing through its output transistors with no audio signal. A pure class €˜B€ amplifier has NO current flowing through its outputs with no audio signal. This eliminates virtually all of the crossover distortion that€s possible with class €˜B€ amplifiers. A class A/B amplifier is much more efficient than a class €˜A€ but without the possible distortion of a class €˜B€.

Metal€“Oxide€“Semiconductor Field-Effect Transistor is a transistor used for amplifying or switching electronic signals. We use it in billions of them. In our computers, our telephones, game consoles, cars, electrical appliances and in this case, our Amplifiers. They are found in systems where information is processed or stored. A MOSFET is basically an electrical switch that allows the flow of electrical current. An electrical switch has two possible states, on or off. The MOSFET performs its most important role in our D Class amplifiers by allowing or preventing the flow of power and creating an efficient amplifier. The €œPulse Width Modulated€ is a design that is significantly simplifies power supplies. It controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. The PWM can increase efficiency, is lighter, smaller, can reduce total cost, productivity and system reliability.