Panavise In Dash Mount, BMW Z4 03~08

Brand New Panavise InDash Mount for 2003-08 BMW Z4 Roadster 75103-902. Model #: 75103-902. The Panavise InDash Custom Mount eliminates exposed holes in vehicle for clean, easy, and nearly invisible phone mount installation. Proudly made in the USA from the highest quality heavy gauge steel, this Panavise Custom Indash Mount has been fitted and produced specifically for your car to provide the utmost convenience and practicality. Complete mounting instructions are included with your purchase and are also available below. . Compatible Cars:. 2003-2008 BMW Z4 ;Mounting Instructions. Mounting Location: Right side of radio Tools Required: Dash Tool, Flat screwdriver or similar, Phillips Screwdriver Hardware Included: None; Step 1: . With Dash tool and flat screwdriver brgin to remove the air vent assemblyInsert flat screwdriver int the inside top of the air vents square holes, one on each side 65mm from the edges and pry down the Metal springs to release. At the same time pry out that side of the ari vent assemebly at the top above the clip. Repeat on the other side. Remove the air vent assembly carefully.. Step 2: . With Phillips screwdriver remove the (4) exposed screws, (2) at top of airvent cavity, and (2) that hold the radio in place. Pull out the radio enought to get under it with a screwdriver to remove the (2) screws at the bottom of the radio cavity.. Step 3: . With dash tool or your hands release the large bezel that surrounds theradio, etc, just enough to get the Indash by PanaVise Mount under the lower leftedge of the bezel. Move the mount up to the lower left radio cavity screw with theleft side 1/2 round to fit under the screw flange. Tighten the screw.. Step 4: . Replace the large bezel, screws, and radio screws. Replace the air vent.. If we don't have it listed please email us..