PM-6009M Programmable Buck-Boost Step Up Down SEPIC DC2DC Converter Power Supply

Features

3CH output:
CH1: Adjustable output: 0.8 to 30V Buck/Boost (SEPIC)
CH2: Fixed 5V output: 5V 500mA Output
CH3: Fixed 3.3V output: 3.3V 300mA Output
Fixed 220KHz Switching Current
Excellent Line and Load regulation

Parameters

Input Voltage Range: 6.5 to 40V
Output: 1CH Adjustable OUT, 1CH 5V and 1CH 3.3V Out
Max Switching Current(Adjustable channel): 5A
Programmable input voltage: 0 to 3.3V
Volt Meter tolerance: 0.5% (+-1)
Operation Temperature: -40 to 125°C
Storage Temperature: -65 to 165°C

Notice

The 5V and 3.3V output is used for small load capability which is less than 500mA, the big current consumption will impact the system's accurate and maybe damaged the module.

Programmable DC2DC Buck-Boost Power Supply

6.5 to 40V INPUT
0.8 to 30V OUTPUT
High precision voltmeter
Coarse and Fine adjustable
3CH Outout (Adjustable / 5V / 3.3V)
SPICE circuit
0 to 3V Programmable voltate:
Vout = Vin * 11 (V)

The PM-6009M support two method for CH1 adjust :

1, Adjust by manual: Please set OPT1 to MANUAL side , then turn the VR , the output voltage will be change between 0.8 to 30V , here have two VR , one is Coarse adjust and the other one is for fine adjust.
2, Adjust by programming: Please set OTP1 to PROG side, the output of CH1 will follow the PROG voltage , the output voltage can be calculate : Vout = Vprog * 11 , and the module will be limit max output voltage within 30V, so if the Vprog higher than 2.7V , the output will be stay on 30V .

Package List

1 x PM-6009M
1 x Red & Blank Cable with Alligator clip
2 x 2.0mm Male Connector Wire
4 x Nuts and Screws
1 x Screwdriver