PICkit 3 In-Circuit Debugger & MCU Universal Programmer Seat ZIF socket & Plug

This is a high-speed and low-cost hardware debugger/programmer. It can be used for in-circuit debugging logic incorporated into each chip with Flash memory.

It allows debugging and programming of PIC and dsPIC Flash microcontrollers at a reasonable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB is connected to the design engineer's PC using a high speed USB interface and can be connected to the target via an debug chip (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming.

Features:
Low cost
Minimum of additional hardware needed for debug
Expensive sockets or adapters are not required. It can now also reprogram any PIC microcontroller.
Note: The In-Circuit Debugger/Programmer is NOT a production programmer. It should be used for development purposes only.

USB (High speed 12 Mbits/s interface to host PC)
Real-time execution
MPLAB IDE compatible (free copy included)
Built-in over-voltage/short circuit monitor
Firmware upgradeable from PC/web download
Totally enclosed
Supports low voltage to 2.0 volts (2.0v to 6.0v range)
Diagnostic LEDs (power, busy, error)
Read/write program and data memory of microcontroller
Erase of program memory space with verification
Freeze-peripherals at breakpoint
Program up to 512K byte flash with the Programmer-to-Go

Package includes:
One debugger and programmer
One red USB cable
One 6-pin ICSP cable
One universal 40-pin ZIF Socket
One offline power supply (INPUT: 100-240VAC 50/60Hz; OUTPUT: DC5V 1300mA)
One DVD disk