Owfeel 2X 1 Channel Receiver DC 12V Wireless Remote Control Switch Set for Motor Lighting Kit with Two Transmitters

Specifications:

Transmitter
Operating Voltage: DC 12V
Operating Frequency: 433Mhz
Vibration Resistance: 334
Chip Type: 1527
Modulation: ASK (Stable, less interference)
Encode Type: Group Coding
Battery Type: 12V 27A(not included)
Remote Distance: 20m (Theoretical value)
Ambient TEMP: -30¡ãC -70¡ãC, Humidity<95%
Product DIM: 54x30x13mm

Receiver
Input Voltage: DC 12V
Operating Frequency: 433Mhz
Output Type: Active Output
Max load: 10A
Ambient TEMP: -20¡ãC -65¡ãC , Humidity<95%
Factory Default: Self-locking
Board DIM: 45x30.5x17mm
Case DIM: 65x37x22mm


Operating Mode:
Hold down button until LED lights. Continue to hold. LED will go off. Continue to hold.
LED will flash once. Release button now for inching mode. Or continue to hold.
LED will flash twice. Release button now for self-locking mode. Or continue to hold.
LED will flash three times. Release button for interlock mode.


Program Mode in:
Hold down button until LED lights and release button while lit. LED will stay on. Press any key on remote. LED will flash twice confirming successful. Now press remote keys and relays will function as programmed. Inching= Single relay will stay on only as long as corresponding remote key is pressed.
Self-locking = Press corresponding key for on, press same key again for off, each relay independently.
Interlock = For each relay: press corresponding key for on (all others off).

Reprogram:
Hold the button down (about 3 sec.) until the LED lights up, then push a button on the transmitter. You should see the LED flash rapidly to show that it is accepting the signal. Release the button and you are finish link transmitter with receiver.

Package Includes:
2X Transmitters (Battery is not included)
2X Receivers
1X User's manual