NEW - NON SLIP rubber toilet seat hinge fittings. A kit to secure two loose toilet seats.

4 NON SLIP RUBBER FITTINGS, ENOUGH TO SECURE TWO LOOSE TOILET SEATS. These fittings are far more hygienic than the plastic SAFE-T BUMPERS and they stabilize the toilet seat by fixing the source of the problem, the loose hinge. They are also easier to fit, no drilling required and you only need a pair of pliers to fit these rubbers. HOW DO THEY WORK - Toilet seats become loose because the holes in the toilet bowl are bigger than the metal rods that fit through them which means that the rods, and hence the hinges and seat, have room to move about. These rubber fittings are squeezed into the gaps between the rods and toilet bowl by tightening the nuts underneath the toilet pan. This eliminates any possible movement of the hinge, AND HENCE THE SEAT. These rubber fittings are designed to fit any METAL hinge which is tightened up from underneath the bowl. If the existing nuts are plastic then metal ones can be purchased from any good DIY store. You will not be able to tighten plastic nuts sufficiently to compress the rubber fittings. PLEASE CHECK THAT ANY MOVEMENT OF THE SEAT IS NOT DUE TO PLAY WITHIN THE HINGE ITSELF -- This would require new hinges. Providing your hinges are in good condition and the threaded rods are TIGHT into the hinges, or are an integral part of the hinge as L Shaped hinges are, then these fitting never fail to work. If your seat is still moving when these fittings have been installed then it is more than likely that you require new hinges. This item is picked and delivered by Amazon, we do not see your order. For technical support please email -- [email protected]