Magnetic Dash Mount Kit for Cell Phones. 2 Dash Balls and Strong Neodymium Magnet (1 Magnet + 2 Balls)

The magnetic phone socket can be adhered directly to the back of most phones and hard cases

Magnetic phone socket installation instruction:
1. Use the alcohol pad to clean the back of the phone case completely. Do not use any other cleaners.
2. The magnet socket is back with FOAM ADHESIVE tape, peel the adhesive backing carefully
3. Position the magnetic phone socket in the center of the phone or phone case, and then press it firmly
4. After application wait for one hour for durable bond

Note: For iPhone 4/4s or any phone with a glass case, after cleaning the phone or case as per instruction above, stick the magnetic phone socket on top of it, following instruction above. Do not use this product on soft and flexible cases

Dash ball mount installation instruction:
1. Before removing the backing, test the position of the dash ball mount in a few different places on dash. For best result, test with phone attached to dash ball mount to choose location.
2. Use the alcohol pad to clean chosen area. Do not use any household cleaners. If the dash ball mount will be installed onto a hard surface such as hard plastic, metal or wood veneer, go to step 3
3. Peel the adhesive backing from dash ball mount carefully, position the ball mount at the dash board and then press firmly into the place
4. Wait for 24 hours before applying device to dash ball mount to allow sufficient cure time for adhesive