MONSTER 600x600mm 120V Silicone Rubber Heater for 3D Printer Heated Beds

REQUIRES 110v POWER, A RELAY AND POSSIBLY A STANDARD WALL PLUG

24 INCHES x 24 INCHES

800 WATTS

You are looking at the ultimate heating element for your 3D printer's bed. This is a premium silicone rubber heater, normally used in industrial environments to heat large tanks of liquid. We had these custom made to be the fastest, most evenly heated elements available. They include a built in 100k thermistor for accurate readings with easy setup. They run off 110v power and will require a relay to turn the heater on and off. These heaters are flexible and WILL REQUIRE a flat build surface such as glass to mount to.

• 24"x24"
• Durable Silicone Rubber Construction
• Extremely Even Distribution of Heat
• Industrial Duty Cycles For Long Life
• Heats To 120 Degrees C in About ONE Minute (assuming adequate power supply)
• Integrated 100k Thermistor For Accurate and Reliable Temperature Readings
• Integrated Thermistor Beta Value 3950K
• Thermistor Leads Are Insulated and Ready To Go
• Draws Up to 7.5 Amps @ 110v So Make Sure Your Circuit Breaker for Your House Can Handle It and the Massive Printer You Have