Krud Kutter ME01 Red Metal Clean and Etch with Bland Odor, 1 Gallon

Save time on most paint projects by cleaning and etching all in one step. For heavily soiled surfaces the original krud kutter should be used as a pre-prep step, to remove excess oil, grease, and dirt. Excess rust should be removed with a wire brush. Krud kutter metal clean and etch is specially formulated to prepare iron, steel, zinc, aluminum, and galvanized surfaces for painting. Removes rust, oil, grease, and dirt. Eliminates paint peeling and other adhesion problems. Do not mix this product with any other chemicals. Directions for use: mix 1 part Krud Kutter Metal clean and etch with 3 parts water in a plastic container. On heavily rusted areas mix with 2 parts water. Apply the premix to metal surface with a paintbrush, spray bottle, sponge or pump up sprayer. Allow the premix to remain on the surface for up to 10 minutes, then thoroughly rinse with water, and wipe dry with rags. Make sure the metal is completely clean and dry, then paint treated surface within 48 hours, to prevent formation of new rust. Contains: phosphoric acid in a water-based solution. Caution: contains phosphoric acid. Severe eye and skin irritant. In case of contact with eyes or skin, flush with water for 15 minutes. If irritation persists, seek medical attention. If swallowed, take large amounts of water. Do not induce vomiting. Get medical attention. Do not mix this product with any other chemicals. Keep out of reach of children. Bland odor. Container size: 1 gallon.