JVCC UHMW Polyethylene Film Tape [15 mil carrier] (UHMW-PE-15): 1/2 in. x 18 yds. (Natural/Translucent)

JVCC UHMW-PE-15 UHMW Polyethylene Film Tape is a 15 mil ultra high molecular weight polyethylene film with an aggressive acrylic adhesive. Its high chemical and abrasion resistance and extremely low coefficient of friction makes this a versatile engineering material for many severe service applications. Materials slide freely over tape surface with no slip/stick tendency. High impact strength and shock absorbing properties. Outwears Teflon trade; many times and is a good replacement when high temperature resistance is not a requirement. Applications include: rub strips on conveyors; bearings and sliding surfaces; chutes and hopper liners; dead plates; wear pads; guide rails; tool tables and fences; furniture and drawer slides/runners. UHMW polyethylene tape is used primarily in automotive and mechanical applications. Meets automotive specs: Chrysler MS-CH612, Ford ESB-M3G123-B, GM 6419M. Wound on a white paper liner. If not otherwise specified lengths shown in dropdown are in feet. NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 12.5mm wide. This tape is typically cut to width from log rolls so most sizes ship on non-branded plain white cores. This item is currently on backorder and expected in around Saturday, February 3, 2018.Technical InformationCore: 3 inch diameterBacking/Carrier: UHMW (Ultra High Molecular Weight) polyethylene filmAdhesive: acrylicRelease Liner: white paperCertifications: Chrysler MS-CH612, Ford ESB-M3G123-B, GM 6419MThickness: 21.3 mils (carrier, adhesive, liner) 17.3 mils (carrier, adhesive) 2.3 mils (adhesive)Adhesion: 50 ounces per inch (to stainless steel test panel) Tensile Strength: 60 pounds per inch (longitudinal) Service/Operating Temperature: up to 300FElongation: 300 %.