Hobbypower 3D Printer Controller RAMPS 1.4 for REPRAP Mendel PRUSA

Specification:
- Fully assembled & tested, no soldering required.
- It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
- The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion.
- A number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
- Size: 11.5cm x 6cm / approx. 4.5in x 2.4in.

Package Includes:
1 x 3D Printer Controller for RAMPS 1.4