Hantek MSO 5102D 100MHz 1GSa/s 1M Record Length 16 Channels Logic Analyzer 2 Channels Oscilloscope
General Description: Mixed Signal Oscilloscope; 100MHz Bandwidth; 1GSa/s Real Time Sample Rate;1MRecord Length; Large (7.0-inch) color display,WVGA(800x480); 16 channels Logic Analyzer,500MSa/s sample rate; Power Trigger mode: edge/pulse width/line selectable video/slop/overtime etc. Detailed Description: *Bandwidth:100MHz *Sampling Rate:Max 1GS/s *Memory Depth(Sample Points):Single-channel max 1M,Dual max 512K(4/16/40K optional) *SEC/DIV Range:8ns-40s/div(stepping in a sequence:2,4,8) *Sampling Rate/Delay Time Accuracy:+/-50ppm in any>=1ms time intervals *Delta Time Measurement Accuracy(full bandwidth) Single,"sampling"mode +/-(1 sampling interval+100ppm x readings+0.6ns) >16 times above average +/-(1 samplinginterval+100ppm*readings+0.4 ns) Sampling interval=SEC/DIV/200 Oscilloscope Vertical,Trigger,Acquisition,Input,Measurement *Logic Analyzer: Sampled Channels:16(divided into 2 groups) Max. Input Impedance:200K(C=10p) Input Voltage Range -60~+60V Logic Threshold Range -8~+8V Max. Sample Rate 500MHz Compatible Input TTL,CMOS,ECL Sample Depth 512KSample Cursors:The difference between voltage cursors deltaV.The difference between time cursors deltaT.1/deltaT calculated by Hz. Measurement:Period and Frequency Record Position:RefA,RefB Trigger: Edge:D0-D15 select slope(rising/falling edge) Pulse Width:D0-D15 select pulse polarity (positive or negative pulse),trigger when(=,not=,>,<) trigger pulse width Code-type:D0-D15 select code-type(H,L,X) Duration:D0-D15 select persist time and trigger when (data terminate/start/delay) Queue:D0-D15 select specific data index(0-3) and code-type(H,L,X) Repeat:D0-D15 select code-type(H,L,X) and repeat times *General Power Supply:100-240V Probe Compensator Output:Output Voltage (typical),About 5Vpp input>=1M ohm load,1KHz Freq.