Geeetech Melzi Ardentissimo controller board kit-Heatbed PCB MK2a,Thermistor,Acrylic plate for 3D Printer Prusa Mendel

The Melzi Ardentissimo is a full-featured Melzi board using the ATMEGA1284P chip used on Sanguinololu. This is a Sanguinololu firmware compatible board, though does have a couple of extra features the Sanguinololu does not - namely the extra Mosfet for the fan, and a software controllable LED. Melzi has micro SD on board as well. A full StepStick clone is on board as well negating the need for external stepper motor drivers.
How do you mount your controller board on your smart printer?
I want to reccomend this acrylic universal support plate to you.

It is of 28mm x 11.5mm and will make it possible for your smart printer to mount most of the board and shield,like Sanguinololu, Teensylu, Ramps1.4, Melzi, Brainwave, Megatronics, Motherboard, Generation 6 and so on.

Package List:
1 x Melzi Ardentissimo Board
1 x USB cable matched with Melzi
1 x Kingston 2GB SD card
1 x Acrylic universal support plate
1 x Heatbed PCB MK2a with soldered resistor and led
2 x 100Kohm NTC Thermistors
2 x Cable for heatbed
10 x 1-pin Female-Female cable
8 x 2-pin Male-Female cable