Gartt ®Openpilot Flight Controller MINI Version CC3D 32 Bits Processor FPV QAV 250 400 Bent Version
The CC3D board is an all-in-one stabilization hardware which runs the OpenPilot  firmware. It can fly any airframe from fixed wing to an octocopter and is configured and monitored using the OpenPilot Ground Control Station (GCS)  software.
 CopterControl from the OpenPilot project  introduces a new generation of multi-purpose aircraft stabilization platforms.  The CC3D has been designed from the ground up to perform the following functions:
- a MultiRotor controller with auto-level, including TriCopters, QuadCopters and  HexaCopters
- a Flybarless Helicopter controller with auto-level
- a Fixed Wing UAV controller
The CopterControl hardware has the following features:
Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and  20KB RAM
3-axis high-performance MEMs gyros and 3-axis high-performance MEMs  accelerometer
Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight  performance.
Software support for Windows, Mac and Linux
Direct high speed USB support with no drivers required, a truly plug and play  device.
Spektrum satellite receiver support
Futaba S-BUS hardware support
Innovative Flexi-port technology for superior port flexibility
4Mbits on-board EEPROM for configuration storage