G2 Ergonomics 40-4K-K - Tamer Throttle Tube

G2 Challenge: Offer one throttle set-up for best overall performance in all off-road conditions. G2 Solution: The Throttle Tamer. The Throttle Tamer incorporates a non-linear ratio between hand throttle rotation and carburetor or throttle body opening. The "pulley", or as we call it, "cam" pulls the throttle cable as the rider rotates the grip/tube. By altering the conventional, circular shaped cam, a vast improvement in control is achieved. The Throttle Tamer has a cam with a reduced radius initially, which requires a slightly farther rotation to achieve the same carburetor or throttle body opening position as a stock throttle. This slightly longer pull makes a HUGE difference in control as the power is rolled on and the rider searches for traction. The radius increases or "ramps up" after ½ throttle to keep overall rotation requires to reach full throttle at or near stock rotation. G2 Key Points: - Machined from 6061 aluminum in the USA! - Self-lubricating Delrin bushings at each end of tube eliminate aluminum-to-aluminum contact and provide an ultra-smooth feel. - Included cams: A 400 cam that starts out approximately 15% smaller than stock. - Fits inside the stock throttle housing to stock cables. - Removable end cap for simple handguard installation. - Installs in minutes! Fits: KTM 4 Stroke 250-350-400-450-500-530-690-950-990 (97-16), Husqvarna 4 Stroke all (97-16), Husaberg 4 Stroke (all)