For MITSUBISHI via Apple IPHONE IPAD Obd II 2 Vehicle Car Auto Diagnostic Fault Code Scanner Scan Tool

This Diagnostic Code scanner supports MITSUBISHI cars Manufactured after 2005 year Support MITSUBISHI OBD-II protocols as follows: ISO 9141 ISO 11898(aka. CAN) ISO 14230(aka. KWP2000) ISO 15765(aka. CAN) SAE J1939 Note: Some models can support not all the functions depends of manufacturer configurations and year.. Read diagnostic trouble codes, both generic and manufacturer-specific, and display their meaning (over 200 generic code definitions in the database). Clear trouble codes and turn off the MIL ("Check Engine" light). Display current sensor data: Vehicle Speed RPM Fuel Consumption Engine Coolant Temp Fuel Pressure Calculated Engine Load Throttle Position Intake Manifold Pressure Air Intake Temp Timing Advance Mass Air Flow Fuel Level Barometric Pressure EVAP System Vapor Pressure Fuel Trim Specifications: Material: automotive grade plastic Operating temperature: -15 to 100 Deg Celsius SSID: WiFiOBD IP: 192.168.0.10 Subnet: 255.255.255.0 Port: 35000 Range: 50 ft (Line of sight) Antenna: Internal Power Consumption: 0.75 Watts (With Power Switch) Wifi Standard: 802.11a/b/g Item size: 9 * 5 * 3cm (3.5 * 2.0 * 1.2in) Item weight: 75g/2.6oz Where can I get the software? You can log on to the apple application store to get your commercial software, such as Dynolicious / DashCommand / Engine Link / Rev / OBD Car Doctor (free) etc.. And There is a software on the CD comes along with the device. You can use this piece of software to config and test the WI-FI OBD AUTO CHECKER. ATTENTION! To connect code scanner with your device necessary WIFI connection