Floor Type 5/8" Manual Tube Bender with 10 Dies Bending Tube up to 180 Degrees

Floor Type 5/8" Manual Tube Bender with 10 Dies Bending Tube up to 180 Degrees

This floor type heavy duty hand bender is the perfect manual bender for bending air lines, brake lines, fuel lines & general hydraulic lines. It features a lightweight design & (4) 5/8" dia. mounting holes at base. This bender was designed to work with mild steel, certain coppers and aluminums, as well as stainless steel. Comes standard with 10 die combinations from 1/4" to 5/8" OD in either 3 or 5 times the diameter radius. Will bend tubing up to up to 180° & has a capacity of 5/8"

• Works with mild steel, certain coppers and aluminums, as well as stainless steel
• Bends tubing up to 180°
• Capacity: 5/8"
• Compact bender designed to make a variety of bends on air lines, brake lines, fuel lines & general hydraulic lines
• Does serpentine bends with ease at very tight radius
• Large heavy duty steel base
• (4) 5/8" dia. mounting holes at base
• 10 Dies included for customizing brackets, supports and other parts on the job site

Included Die Sets:

• 1/4 x 3D (6.350 mm x 3D)
• 1/4 x 5D (6.350 mm x 5D)
• 5/16 x 3D (7.938 mm x 3D)
• 5/16 x 5D (7.938 mm x 5D)
• 3/8 x 3D (9.525 mm x 3D)
• 3/8 x 5D (9.525 mm x 5D)
• 1/2 x 3D (12.7 mm x 3D)
• 1/2 x 5D (12.7 mm x 5D)
• 5/8 x 3D (15.875 mm x 3D)
• 5/8 x 5D (15.875 mm x 5D)