Flat-Face-Idler-O-D-438-In

Flat Face Idler, Shaft Required 6AGL6, Outside Dia 4-3/8 In, Hub Dia 1-7/8 In, Face Width 1-1/16 In, Bore Dia 1 In, Length through Bore 1-1/4 In, Construction Cast Iron, Needle Bearings, For Use With Drive Tighteners And Tightener Shafts, For Use On Back Side Of V-belts, Gearbelts And Drive Tighteners Flat-Face Pulley IdlersPrevent belt slippage. Can be used with flat belts, gearbelts, or the back side of v-belts. Include needle bearings. For use with drive tighteners and tightener shafts, see page 171.