FLUX 425 20 011 Drum Pump, 99.98% Emptying, 1.6" Dia, Type F 425 S-41, 39", 316 Ti SS, ETFE Impeller

PUMP ONLY! DOES NOT INCLUDE MOTOR/ENGINE! FLUX 425 20 011 Drum Pump, 99.98% Emptying, 1.6" Dia, Type F 425 S-41/34, 39" Long Tube and Shaft in 316 Ti stainless steel, ETFE Impeller, O-Rings and Seal in FKM. Maximum Temp 212 F. Tube Outer Diameter 1-19/32" (41mm). Mechanical Seal in Ceramic Oxide, PTFE/Carbon. Outlet connection is BSP 1 1/4" male. Select this FLUX Pump if you are not prepared to accept any residual liquid in the drum in order to avoid problems and costs of disposal or to avoid losing high value liquids. Before the motor is switched off, the flowback stop valve at the pump inlet must be closed by operating the lever. This prevents the liquid flowing back into the empty drum. FLUX drum pumps in Stainless Steel 316 Ti are approved according to ATEX-Directive 94/9/EC for use in Zone 0, temperature class T4, for transferring highly flammable liquids out of portable drums or containers. When using the pump with a discharge hose (of approximately 6.5 ft) and a hand nozzle, the delivery rate will be approximately 18 GPM. Depending on the motor type a 55 GAL drum can be emptied within 3. 4 minutes. The delivery rates shown in the performance charts are obtained at the outlet connection of the pump. Special advantages: Especially easy operating of the pump; Optimum use of the liquids; Remaining liquid of less than 0.11 gallon. Tube Set ONLY! NO MOTOR OR HOSE INCLUDED.