Dshot APM2.5.2 APM2.6 Pixhawk Power Module cable V1.0 Output BEC 3A with XT60 Plug

Notice:
we have many buyer burned this cable when connet it to 6S battery because he solder the cable to our this module cable.please don't connect or solder any other cable on this current cable,otherwise it will be burned Power Module is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6P cable
The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery
Special for APM2.5.2 APM2.6 Pixhawk flight controller

Note:

The Power Module is only designed to power APM/Arduflyer, a RC receiver and accessories (GPS, Radio telemetry)
It is not designed to power servos
Use your aircraft's own ESC/BEC for that

Features:

XT60 Plug Max input voltage: 30V
Max current sensing: 90A Voltage and current measurement configured for 5V ADC Switching regulator outputs 5.3V and 3A max 6P molex cable plugs directly to APM/Arduflyer 2.5's 'PM'
connector Specifications: Dimension(mm): 25 x 21 x 9
Weight(g): 17(include all wire)
Dshot is US trademark,all the Dshot products are selling by our own company,we never Authorize other company to sell it