Dshot APM 2.5.2 2.6 Current Sensor Power Module Cable Xt60 Plug

Power Module is a simple way of providing your APM/Arduflyer with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6P cable
The on-board switching regulator outputs 5.3V and a maximum of 3A from up to a 7S LiPo battery
Special for APM2.5.2 APM2.6 Pixhawk flight controller

Note:

The Power Module is only designed to power APM/Arduflyer, a RC receiver and accessories (GPS, Radio telemetry)
It is not designed to power servos
Use your aircraft's own ESC/BEC for that

Features:

XT60 Plug Max input voltage: 30V
Max current sensing: 90A Voltage and current measurement configured for 5V ADC Switching regulator outputs 5.3V and 3A max 6P molex cable plugs directly to APM/Arduflyer 2.5's 'PM'
connector Specifications: Dimension(mm): 25 x 21 x 9
Weight(g): 17(include all wire)
Dshot is US trademark,all the Dshot products are selling by our own company,we never Authorize other company to sell it