Dental Power Dental Sealing Machine Seal Autoclave Stream Sterilization Dentist Equipment

a)Note: In order to make the sealing better, wait for 1 or 2 seconds to release the sealer arm after the red LED goes off. If the heating time is too long or insufficient the sealing might be inefficient (the envelope may be stuck to the sealing area when it is pulled or be visibly badly-sealed). To correct this, adjust the timer properly. Once adjusted it is not necessary to perform any other adjustment to continue sealing.

b)Additional information
1.Keep the sealing platform always clean. The accumulation of waste on the sealing area will reduce the life cycle of the resistance and the insulating material. For an effective cleaning, wait for the sealing area to cool down and use a cloth slightly moistened with alcohol.
2.If the insulating material lower tape is worn the sealer may go faulty and the resistance may be damaged. Being so, every time the resistance is replaced, please also check the insulating material tape and replace it if it is worn.
3.If it is necessary to replace the resistance or the fuse, use only those which have the same specifications as the genuine parts.1)New concept of design; 2)Economicl and practical; 3)Designed to avoid cutting accidents and protect hands.

c)Technical parameters
Model:Sella I-30C
Power input:110 V 50/60 Hz
Power output:900W
Seal width:8 mm
Seal length:32~33 cm
Dimensions (W * L * H):500*120*175 mm
Gross weight:3.7 kg