DYNOJET - AUTOTUNE O2 CONTROLLER - POWER COMMANDER V - USE ON METRIC MOTORCYCLES - FREE SHIPPING - NEW 2009

The Auto tune kit is a universal product that can be utilized on any model using the PCV and which has a 12v power source. • Many stock and aftermarket exhausts come equipped with an O2 sensor. If your system uses a M18x1.5mm thread then you can simply use this location for the Auto tune sensor. If you have to drill a hole for a new bung (mild steel bung included), we recommend doing so before the catalytic converter (if applicable). Positioning the weld bung in a location where multiple cylinders collect is the preferred location. If your application has a "2-into-2"design, it's recommended to position the weld bung /sensor approximately 6" from the exhaust port on the respective cylinder you wish to tune. • Mount the weld boss in a manner that reduces the risk of moisture contamination on the sensor. Condensation can build up in the exhaust pipes and potentially damage the sensor. Ideally, you should orient the weld boss so the sensor is between the 9 o'clock and 3 o'clock position. A 10° inclination off the horizontal plane should be considered a minimum. Note: Verify you have adequate clearance for the sensor and wiring harness.