DATAKOM DKG-114 Generator Manual and Remote Start Control Panel/Controller

WE DO NOT SHIP THIS PRODUCT TO USA AND CANADA

The DATAKOM model DKG-114 is a low cost, microprocessor controlled generator control unit designed to start and stop the genset both manually and remotely. The manual control is made using the pushbuttons on the front panel. The remote control is made via the remote start input signal.
In the STOP position, the DC supply is removed from the module, thus zero power consumption is achieved.
The unit powers up when the RUN button is pressed or battery + is applied to the REMOTE START input. This will also energize the fuel solenoid relay. The engine is automatically started 3 times until operation. Once the engine is running, the device monitors the internal protections and external fault inputs. Only the first occurring alarm will be displayed, disabling further alarms.
If the STOP button is pressed or the REMOTE START signal is removed, the engine will be stopped.
The unit offers jumper selectable operating parameters, which lets it to be used in a large variety of applications. The jumper options select the operating voltage of the unit, the auxiliary relay function, the engine running signal type and the cooldown cycle.

The unit fits into a standard 72x72mm panel meter opening and offers a very cost effective and space saving solution for the basic genset control. Thanks to the completely sealed structure, IP65 protection degree is achieved from the front panel. The unit works on both 12 Volt and 24 Volt gensets.

More on controllers4generators.com