Behringer PB600 Pedalboard with Power Supply - 6-pedal
Universal Effects Pedal Floor Board with 9 V DC Power Supply and Patch Cables
When effects are an integral part of your rig, their power adapters and patch cables can often be the most vulnerable part, and the most likely to sabotage your set if they're not pampered. Rather than tossing your pedals, power adapters and all other cabling into a duffel bag after a gig, keep them safe - and ready to rock at a moment's notice - with the PB600.
This awesome pedal board makes hooking up six 2.5" x 4.5" pedals as easy as hooking up just one (of course, if you're using pedals that aren't 2.5" x 4.5", the snug foam padding can be cut to accommodate pedals of varying shapes). The PB600 includes 1/4" patch cables, so you can leave your pedals connected to one another, ready to pass signal even when you're transporting them. It also comes with 1 x 6 daisy chain cabling so that when you plug in the 1.7 A power adapter, all your pedals receive power. Meanwhile, all cabling remains safe and free of strain. Failure is almost guaranteed when you're dealing with a rat's nest of loose cabling, but with the PB600, your effects chain is always safe and organized.
Connect your guitar, bass or keyboard to the single 1/4" input in the upper right corner of the board. A pair of 1/4" FROM EFFECTS jacks in the upper left corner allow you to connect stereo effects, and two 1/4" OUTPUT TO AMP jacks send a left and right stereo signal to up to two amps.
When it's time to load out, just unplug the power supply, disconnect your guitar and amp, put the lid back on the PB600 and slide the locking latches back into place. The heavyimpact plastic casing will protect your pedals from the very worst dings, scrapes and scratches the road throws your way.