Bartolini HR-5.2AP/918 Preamp Harness - 3-Band EQ w/ 5 Control Knobs - Active/Passive Switchable - Pre-wired for a Two-Pickup Installation

Give your guitar or bass a new voice with a custom Bartolini on-board preamp. These harnesses are prewired for easy installation and offer a variety of configurations to meet your needs. Bartolini is one of the most respected & trusted pickups & electronics builders in the industry and offers some of the finest electronics using only the highest-grade materials. Every Bartolini preamp & pickup is hand-built right here in the USA.

All preamps feature a Gain trim pot on the module for fine-tuning, and all tone & blend pots feature smooth action & center indents with 6mm knurled split shafts. Controls knobs with set screws are recommended, but not included.

Controls are:
-Volume with Push/Pull switch for Active/Passive modes
-Pickup Blend
-Bass Boost/Cut
-Mid Boost/Cut with Push/Pull for frequency selection (switch between hi-mid & low-mid)
-Treble Boost/Cut

What's in the box:
(1) Pre-wired Preamp Harness
(1) Extra Battery Connector for 18 Volt installations (requires soldering if used)
(1) Wiring Diagram

PLEASE NOTE: Preamps that have been installed or attempted to be installed are not returnable unless defective. Check to make sure you have the correct control configuration & check the fitment before attempting to install it.