Altec Products, Show N Go Electric Powered License Plate Frame, Remote Control Automatic Hide License Plate
Go from showing your license plate for the world to see, to discretely hiding your frame and display your car's true beauty. From Altec Designs, this Show N Go license plate frame mechanism will enhance the aesthetic of your motor vehicle by simply hiding your license plate. This complete system has a patented robust design that will ensure trouble free operation. Hide your license plate the easy way with this fool-proof license plate transport; simply push the button and your plate frame will either display or be stowed.
Refer to images for reference. 1. Mount Receiver: Locate the receiver on the fender panel such that radiated heat from the engine is blocked. Suggested locations are behind the fuse box or battery. The black and red wires from the receiver can be directly connected to the battery after step #3, since the current draw is extremely low. Feed the two-lead wire with motor connections from the receiver in between the radiator baffle and the body so it exits forward below the car on the passenger side. Pull it a foot or so out in front of the car. Plug the wires into the motor and secure them per step 2 & 3. Then, attach the receiver to the fender-well using the doublebacked tape provided. Clean up the wiring by covering conductors with cut lengths from one of the two wire sheaths. Loop up extra wire and secure it as needed. For maximum receiver range, extend the antenna and keep it separated from other wire conductors. Complete the connection to the battery after the leads are attached to the motor. 2. Install Wire Sheathing: Slip the other 12" length of wire sheathing over the two-lead wire near where it connects to the motor, as shown.