ATR Tile Leveling System 2mm Edge Spacer - 100pcs (Wall & Floor)

ATR Tile Leveling is a 2 Part System with Spindles (Reusable) and Spacers that eliminate lippage in tile installation (NO TOOLS Needed).

While every other system require 360 units for 100 pieces of tile, ATR require only 117.

You only need 1 cross spacing plate for 4 tiles NOT 4 Clips like every other Leveling System.

Example of the difference between ATR to other leveling system - for 100 pieces of tile project ATR use total of 117 spacers with approximately cost of $29.99 compare to any other leveling system 360 spacers with cost of $44.00. About 33% saving in money of spacers and over 66% time saving in Labor of saving on installing additional 243 pieces.

Grout spacer 5/64" (2mm) - Tile thickness 15/64 - 51/64 (1/4 - 3/4) (6mm-20mm)

Advantages of the ATR Tile Leveling System:

- Creates a lippage free surface
- Keeps tiles in place while drying
- Professional finishes every time

How to use 5 Easy steps:

1. Screw spindle into spacing plate until screw tip is just visible at underside of plate.
2. Insert Tile Levelers spindle with spacing plate attached in between two tiles.
3. Lay adjacent tiles until all four corners, or two corners for the edge spacing plate are met.
4. Tighten spindle clock wise firmly until all four corners are lifted flush.
5. Remove spindle once tile adhesive is dry.