ATR Plastic ATR2WT100 ATR Leveling System T Spacers Walls and Floors 2mm 100

ATR Tile Leveling Alignment System 100. T Spacers 2mm. For use with brick pattern, subway layout, herringbone, etc. Apex Coverage Area - 85 Pieces of tile compare at 50 pieces of tile with other leveling system. Tiling made easy with the ATR Tile Leveler. T spacer 3/32" (2mm) - Tile thickness 15/64 - 51/64 (1/4 - 3/4) (6mm-20mm). You only need 1 t spacing plate for 3 tiles intersection NOT 3 Clips like every other Leveling System. While every other system require 578 units for 102 pieces of tile ATR require only 187. Very easy to learn and use at any skill level. Advantages of the ATR Tile Levelers. Creates a lippage free surface. Keeps tiles in place while drying. Assists in aligning tiles. Stress free installation. Professional finishes every time. Very simple and easy to use. Saves time. Suitable for floors and walls. Suitable for indoor and outdoor uses. Reusable spindle. Australian design and Australian made. Example of the different between ATR to other leveling system. 102 pieces of tile project ATR use total of 187 T spacers with approximately cost of $62.33 compare to any other leveling system 578 spacers with cost of $107.70 and up. About 33% saving in money of spacers and over 66% time saving in Labor of saving on installing additional 391 pieces. How to use 5 Easy steps. 1. Screw spindle into spacing plate until screw tip is just visible at underside of plate. 2. Insert Tile Levelers spindle with spacing plate attached in between two tiles. 3. Lay adjacent tiles until all four corners, or two corners for the edge spacing plate are met. 4. Tighten spindle clock wise firmly until all four corners are lifted flush. 5. Remove spindle once tile adhesive is dry.