ACCU-RISER BRAND Molded Black Cheek Rest

ACCU-RISER MOLDED CHEEK REST MADE IN USA Ambidextrous cheek rest incorporates two interchangeable rubber cheek pads, one 5/8" and 1" which can be switched to better fit your line of sight. A proper cheek weld reduces felt recoil and aligns your optic sight. This will greatly improve comfort and accuracy on your rifle or shotgun. The hard nylon base can be mounted temporarily with supplied 3M double sided tape and held fast with or without a supplied Velcro cinch strap, or unit can be permanently mounted with two screws which are then covered with the pad for a clean secure mount. Fits most factory rifles and shotguns with classic style stock without cheek pads (not aftermarket stocks). Does not fit Hogue overmolded stock or Monte Carlo If you think your stock is wide then it will not fit. Please keep in mind the bolt travel and removal of bolt action rifles when mounting a cheek pad. In this model, cheek pad may be removed from base for bolt removal. No need to remove entire unit. MOUNTING INSTRUCTIONS: ~ Position the ACCUR-RISER cheek rest on your weapon. ~ Bolt action, check that the bolt can be cycled and removed for cleaning before mounting to stock. ~ Check fit to stock (underside of base can be trimmed for wider stocks). ~ If mounting temporarily, cut a 1" length of 3M tape and use the velcro cinch strap. ~ If mounting permanent, use the 3" of 3M tape and use the velcro cinch strap. ~ Permanent without strap, drill two 5/16" holes and fasten with two #6 screws provided with kit. ~ 5/8" or 1" cheek pads press onto base easily by pressing down from front to back. ~ Remove pads from base by prying with a dull kitchen knife. ACCU-RISER MOLDED CHEEK REST Comes with: Two interchangeable pads 5/8" & 1" ~ 3" of double sided 3M tape 2 - #6 screws to mount permanently Mounting instructions MADE IN USA