4 Axis USB CNC Breakout Board Nema23 Stepper Motor Driver Dual Shaft Stepper Motor 4 Axis Interface Board CNC Kit with Hand Controller

1. Power supply:400W 36V 11A

2. Dual shaft stepper motor:
Current:3A
1.6Ohm Phase Resistance
6.8mH Phase Inductance
Holding Torque:280N.cm
Detent Torque:12N.cm

3. Stepper motor driver:
drive the small and medium phase(the two or four phase current lower than 4A)hybrid step motor.
Power supply voltage: 12 to 40VDC
chopping wave frequency: 20kHz
TTL compatible input signal
Maximum current: 4A
2、1/8、1/16、1/32、1/64、1/128、1/10、1/20 optional subdivision precision

4. 4 Axis USB CNC Breakout Board:
Board operating input voltage:15-36V
Limit interface operating operating voltage:12V
Stepper motor control signal output voltage:5V
Minimum configuration:
USB 2.0 PROT
CPU：1GHz；
DISK:500MB
RAM:512MB
net FRAMEWORK 3.5SP1
DIRECTX9 graphics device with WDDM 1.0 or higher driver
Recommended configuration:
CPU：2GHz Dual-Core
DISK:1G
RAM：2GB
.net FRAMEWORK 3.5SP1
USB 2.0 PORT
DIRECTX9 graphics device with WDDM 1.0 or higher driver

What`s in box?
1 x USB cable
4 x stepper motor driver
1 x breakout board
1 x Hand controller
4 x Dual shaft stepper motor
1x power supply